Etc Cobalt Light Server Setup Guide Uživatelský manuál stáhnout pdf (Strana 2)

ETC Setup Guide

Cobalt Light Server

Cobalt Light Server Setup Guide Page 2 of 3 Electronic Theatre Controls, Inc.

Hardware Setup

Connect Cables

Step 1: Attach the appropriate IEC power cord to the power connector, then to the IEC receptacle.

Step 2: Connect any monitors to the proper ports on the back of the Light Server.

Step 3: Connect the USB mouse and keyboard to the USB connectors.

Step 4: Attach a network ethernet cable to an ethernet port.

Step 5: Connect optional cables as desired including remote trigger, MIDI, DMX512/RDM, and

phone remote.

Step 6: When all connections are made, switch the hard power switch on.

Step 7: Press the soft power switch, on the front of the unit, to power up the Light Server.

Note:

The Cobalt Light Server can support up to three DVI-I monitors.

Note:

If the unit does not power up, check the rear panel to ensure the hard power switch

is on.

Hard Power Switch

DMX512/RDM

Phone

Remote

DVI-I Video

Ports

Audio Ports

(Audio In Not

Currently Enabled)

IEC Receptacle

MIDI In

& Out

Remote

Trigger

USB

Ethernet

Ports

1 2 3

Žádné komentáře

Etc Cobalt Light Server Setup Guide Uživatelský manuál Strana 2