ETC Source Four LED Series Uživatelský manuál stáhnout pdf (Strana 11)

Introduction 6

Safety

The Source Four LED series fixtures are intended for professional use only. Read entire

User Manual before using equipment.

WARNING:

Note the following safety warnings before use:

• Do not mount the Source Four LED series fixture on or near a flammable

surface.

• Do not use this fixture with a damaged power lead. If the power lead

(cordset) is damaged, it must be replaced.

• Do not use this fixture if glass lens is deeply scratched or cracked.

Damaged lenses must be replaced.

• Use theSource Four LED series fixture in dry locations only, where

humidity does not exceed 90 percent (non-condensing). These fixtures are

not intended for outdoor use.

• Mount and support the fixture only by the primary suspension holes in the

yoke or floor standing yoke.

• Suspend the fixture from a suitable structure using only the hardware rated

for the weight of the fixture.

• In addition to primary suspension, attach a safety cable (ETC Model 400SC

or other approved safety cable or device) to the fixture housing.

Appropriate attachment point (hole) is provided in the protruding tab on the

fixture housing.

• Disconnect the unit from power and from DMX before all cleaning and

maintenance.

Note:

• Maximum recommended ambient operating temperature: Ta=40°C (104°F)

• Maximum anticipated external surface temperature: Tmax=80°C (176°F)

• External temperature after 5 minutes of full-brightness operation at 25°C (77°F)

ambient: 29.9°C (85.8°F)

• External Temperature (steady state achieved) at 25°C (77°F): 41.5°C (106.7°F)

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 95 96

Žádné komentáře

ETC Source Four LED Series Uživatelský manuál Strana 11